02.002 – How to make a 2 way lift

This is really simple I don't think it will even take a full page!

All you really need is cardboard!

First of make the basic shape of your lift it does not have to look all complicated just needs to be big enough to put in a 2 way switch and a sackperson.

In your tools bag place a 2 way switch into your lift and glue it in place you can put it on the floor, side or even the roof!

Once you have done this attach the lift where you want it to move to using a piston found in the tools bag, for this I'm just going to place a bit of dark matter in the middle of nowhere. You would usually attach it to the next floor or something. Try make it as straight as possible.

Then go into the settings and make the piston “Minimum Length” 0.0 or 1.0 or 2.0, something small not big (unless you don't want it to move much)  and the time it takes to get to its destination. Then choose to make the piston stiff or not. Haha I know your laughing.

After this attach the switch to the piston using the green wire sticking out of the 2 way switch. Then make that switch's behaviour “Direction”. Now when you pull the switch one way it will go up and the other down. (unless you make it go left and right)

And we are done! See, simple!